How to use the door hinge
1. Clear the minimum spacing between door leaves
When installing the hinge, it is necessary to confirm the minimum distance between the door leaves. If the distance is not well grasped, there may be collisions, and it is not easy to open and close, which will harm the beauty of the door and it is not easy to use.
2. Determine the total number of door hinges according to the door panel
After confirming the distance between the assembled door panel and the door hinge, you need to install it according to the number of door hinges used. The key to the number of door hinges is to install the door panel aspect ratio. Generally, the aspect ratio is 1500mm, and the net weight is For the door panel in the middle of 9-12㎏, you should choose 3 door hinges up and down. All normal is 2, and the total number of door hinges can be moderated according to the aspect ratio and net weight.
3. Installation method
The assembly method of the door hinge is very critical. The opening and closing door is divided into three installation methods: full-cover door, half-cover door and embedded door according to the part of the door frame and the side panel. The full-cover generally covers the side panel, and the half-cover door Covering half of the side panel, especially suitable for a baffle in the middle, you must install a wooden cabinet above the three doors, and the embedded door is installed inside the two side panels.
4. Location and direction
Before installing the gate, use a carpenter’s pen to determine the location. The drilling height is generally around 5mm, and then use a pistol drill or a woodworking hole opener to make a mounting hole of about 35mm on the top of the door. The depth of the hole is generally in 12mm up and down, then put the door hinge into the hinge cup hole on the door panel and fix the hinge cup with self-tapping screws.
5. Check after assembly
After the door hinge is placed in the door plate cup hole, open the door hinge, then insert it and align the baffle at both ends, and fix the base with self-tapping screws. After the assembly work, the actual effect of the discharge port must be checked back and forth. Generally, the door hinges can be adjusted in six directions, right and left, and the upper and lower places of the double door are moderate.